How To Pick A Lock With A Bobby Pin Step By Step

How to pick a lock with a bobby pin step by step Without the right set of tools tubular locks are nearly impossible to pick.

How to pick a lock with a bobby pin step by step. Make a slight bend at the tip of the straight end. Now take a second bobby pin and bend the closed end to one side so it forms a 90 degree angle. Tubular locks have a set of pins and a tumbler. Note that throughout the entire process of picking and setting pins we must continuously hold tension on the plug.

Apply minimum torque to the tension wrench insert the bobby pin into the keyway make use of a vibrating motion or scrubbing over the pins after a few sec. But they re set up in a circular pattern. To pick a lock you ll need a tension wrench which will turn the lock and a pick which will pop the pins inside of the lock so that it can be turned. If you don t have professional lock picking tools you can pull the end of a paper clip out to form a 90 degree angle with the rest of the clip or use the bumpy end of a bobby pin for your pick.

Insert the pick into the keyhole and gently scrub over the pins inside the lock going from inside to outside in one direction then pull the pick out. Once again insert our bobby pin tension wrench into the lock and give it the necessary pressure to bind the first binding pin. To pick a lock with a bobby pin first bend open a bobby pin until it makes a 90 degree angle and remove the rubber piece on the straight end. So you need a special tool to map these pins in order to pick them.

Take bobby pin a shown on the left and bend it like so. Repeat this process until all the pins. Repeat this process until you hear the lock. The first step in picking a lock with bobby pins is to create the tools.

The first step is to insert the tension wrench into the lock and turn it the same direction that you would turn the key. However if you have the proper tools you ll be able to map the pins and pick a tubular lock with ease.